Manual.ly Logo

Webasto Pure Manual

0,0 · 0 Bedømmelser

PDF-manual · 66 Sider

Dansk

M: QW-35-FL
side

/ 66

Loading...
e960bb56323879fb72c33dcf0aaadd4134da page 3
Webasto Pure 3
1 General information
1.1 Purpose of the document
These operating and installation instructions are part of the
product and contain information for the user to ensure safe
operation and for the authorised electrician to carry out
safe installation of the Webasto Pure charging station.
1.2 Using this document
Carefully read the operating and installation instructions
before installing and starting up the Webasto Pure.
Keep these instructions ready to hand.
Hand these instructions on to the following owner or
user of the charging station.
1.3 Intended use
The Webasto Pure charging station is designed for charging
electric vehicles in accordance with IEC 61851-1, charge
mode 3. In this charge mode, the charging station ensures:
■■
The voltage is not applied before the vehicle has been
connected correctly.
■■
The maximum power is calibrated.
The AC/DC converter is in the vehicle.
1.4 Use of symbols and highlighting
DANGER
Hazard with a high degree of risk which, if not avoi-
ded, will lead to death or serious injury.
WARNING
Hazard with a moderate degree of risk which, if not
avoided, may lead to minor or moderate injury.
CAUTION
Hazard with a low degree of risk which, if not avoi-
ded, will lead to minor or moderate injury.
The note denotes a special technical feature or
potential damage to the product.
Reference to separate documentation
Description of a precondition
Description of an action
1.5 Warranty and liability
Webasto shall not accept liability for defects or dama-
ge due to the failure to comply with the operating and
installation instructions. This liability exclusion particularly
applies to:
■■
Improper use.
■■
Installation and initial operation by a non-authorised
electrician.
■■
Repairs not carried out by a Webasto service workshop.
■■
Use of non-original spare parts.
■■
Conversion of the unit without permission from
Webasto.
2 Safety
2.1 General information
Only persons over the age of 18 are permitted to use the
charging station.
The Webasto Pure charging station has been developed,
produced, tested and documented according to the
relevant safety regulations and environmental requirements.
The device must only be used in a technically faultless
condition.
Have any faults that adversely affect the safety of persons
or of the device rectified immediately by an authorised elec-
trician in accordance with nationally applicable regulations.
It is possible that the signalling in the vehicle differs
from that described here. Always read the operating
instructions of the respective vehicle manufacturer
and always observe these.
2.2 General safety information
■■
Hazardous voltages are present within the casing.
■■
Check charging station for visual damage before
use. Do not use the charging station if damaged.
■■
Installation, electrical connection and initial ope-
ration of the charging station must only be carried
out by an authorised electrician.
■■
Do not remove the cover of the installation area
whilst in operation.
■■
Do not remove markings, warning symbols and
the rating plate from the charging station.
■■
The charging cable must only be replaced by an
authorised electrician in accordance with the
installation instructions.
■■
It is strictly prohibited to connect other equip-
ment/devices to the charging station.
■■
When not in use, store the charging cable in the
designated holder and lock the charging coupling
in the charging station. Loosely wind the charging
cable around the charger casing so that it does
not touch the ground.
■■
Make sure that the charging cable and coupling
cannot be driven over, trapped and are protected
from any other hazards.
■■
Immediately notify Webasto Customer Service
if the charging station, charging cable or the
charging coupling are damaged. Do not continue
using the charging station.
■■
The vehicle must be unoccupied during the char-
ging procedure.
■■
Prevent the charging cable and coupling from co-
ming in contact with external heat sources, water,
dirt and chemicals.
■■
Do not attach extension cables or adapters to the
charging cable.
■■
Remove the charging cable by pulling on the
charging coupling only.
■■
Never clean the charging station with a high-
pressure cleaner or similar device.
■■
Switch off electrical power when cleaning the
charging sockets in the charger coupling.

Chat med din Webasto Pure manual ved hjælp af AI

Få øjeblikkelige AI-svar fra din Webasto Pure manual

Spørg om alt vedrørende Webasto Pure. Svarene kommer fra denne manual med henvisning til de sider, de er baseret på.

Pure Vedligeholdelsesplan

Forud for hver brug
Tjek ladestationen for synlige skader

Undersøg ladestationen, kablet og koblingen for synlige skader før hver brug. Brug ikke enheden, hvis den er beskadiget.

Vis i manualen (side 3)
Efter behov
Rengør huset med en tør klud

Tør kun installationen af med en tør klud. Brug aldrig højtryksrenser, ætsende midler, voks eller opløsningsmidler.

Vis i manualen (side 9)
M: qwen/qwen3.8-flash

Stil et Spørgsmål

0/1000

Anbefaler du Pure?

Ja Nej

Ofte stillede spørgsmål

A

Nej, installation og elektrisk forbindelse skal strengt udføres af en autoriseret elektriker for at sikre sikkerhed og overholdelse af lokale regler.

Er dette svar nyttigt?

A

Et lilla LED indikerer, at ladestrømsgrænsen er aktiveret, typisk med en maksimal input på 20 A for enkeltfase opladningskonfigurationer.

Er dette svar nyttigt?

A

Tryk og hold touch kontrolswitchet i mindst 10 sekunder for at initiere en systemselvtest og nulstille fejl efter de er blevet rettet.

Er dette svar nyttigt?

A

Ja, den har en IP54 rating, der tillader brug i beskyttede udendørsområder som carporte, men den bør ikke udsættes for direkte regn eller højt tryk vaskere.

Er dette svar nyttigt?

A

Du kan konfigurere strømmen ved hjælp af DIP-switches, men nogle modeller har fabriksgrænser, der ikke kan overskrides, såsom at opgradere en 11 kW enhed til 22 kW.

Er dette svar nyttigt?

M: QW-35-FL

Fordele og Ulemper

Fordele

  • Integreret reststrøm overvågning forbedrer sikkerheden mod DC-fejl
  • Slank sort finish passer smidigt til moderne arkitektoniske stilarter
  • DIP-switches tillader fleksibel konfiguration til 1-fase eller 3-fase systemer
  • IP54 beskyttelsesklasse sikrer holdbarhed mod støv og vand
  • Intuitive LED indikatorer giver klare visuelle statusopdateringer
VS

Ulemper

  • Installation kræver en certificeret elektriker, hvilket øger den oprindelige omkostning
  • LED advarselfarve kan ikke dæmpes i modsætning til standby farver
  • Maksimal effekt kan være begrænset til 20 A for enkeltfase opsætninger som standard
  • Enheden kan ikke opgraderes fra 11 kW til 22 kW via software efter fabrikskonfiguration
  • Udskiftning af opladningskabel er begrænset til autoriserede fagfolk
M: QW-35-FL

Produkt Specifikation

Antal ladepunkter

1

Ladetilstand

IEC 61851-1 (tilstand 3)

Antal faser

3-faset

Spænding

400V (AC)

Kontaktortype

Type 2

Forbindelsestype

Kabel 4,5m

Installation

Vægmonteret

Autorisation

Nøglekontakt

Beskyttelsesklasse

IP54

Dimensioner

22,5x44,7x11,6cm (BxDyH)

M: QW-35-FL

Produkt Beskrivelse

Opdag Webasto Pure Black Edition Manual

Webasto Pure Black Edition repræsenterer et højdepunkt i elbilsopladningsteknologi, der blander slank æstetik med robust ydeevne. Designet til både boligmiljøer og kommercielle miljøer sikrer denne opladningsstation sikker, effektiv og pålidelig strømforsyning til din elbil. Manualen tjener som din omfattende guide til at låse op for enhedens fulde potentiale og tilbyder detaljerede indsigt i installation, drift og vedligeholdelse uden unødvendigt jargon.

Drift inden for de strenge sikkerhedsparametre i IEC 61851-1 standarderne bruger Webasto Pure avanceret ladetilstand 3 teknologi. Dette sikrer, at spænding kun anvendes, når køretøjet er sikkert forbundet, hvilket beskytter både bilen og brugeren mod elektriske farer. Enheden har et intuitivt LED-indikator system, der kommunikerer status på et øjeblik, fra standby blå til aktiv grøn, og fejl rød. Uanset om du konfigurerer den til en 1-fase eller 3-fase forsyning, tillader DIP-switch indstillinger præcis strømkalibrering op til 22 kW.

Sikkerhed er afgørende i designfilosofien hos Webasto Thermo & Comfort SE. Pure Black Edition inkluderer integreret reststrøm overvågning for at forhindre farlige DC-fejlstrømme. Installation skal udføres af en kvalificeret elektriker, der kan sikre korrekt jordforbindelse og overholdelse af lokale regler vedrørende sikringer og RCD'er. Enheden er bygget til at tåle hårde forhold med en IP54 rating, hvilket gør den velegnet til garager, carporte og beskyttede udendørsområder, mens den modstår støv og vandstråler.

Udover standardopladning tilbyder Webasto Pure tilpasselige funktioner tilgængelige gennem dens nøglebetjent switch. Brugere kan gå ind i programmeringsmode for at justere LED-lysstyrke eller deaktivere 20 A ladestrømsgrænse på specifikke varianter, såfremt lokale love tillader det. Det inkluderede monteringskit forenkler væginstallation og sikrer, at enheden forbliver stabil og sikker. Ved at overholde retningslinjerne fundet i Webasto Pure Black Edition Manual kan ejere nyde en sømløs opladningsoplevelse, der prioriterer levetid, sikkerhed og effektivitet.

M: QW-35-FL

© Copyright 2026 Manual.ly